− If the vehicle model does not have an ignition lock, the identification transmitter must be located in the vehicle interior. The coding procedure may be terminated if the identification transmitter is not inserted in the ignition lock. − On vehicles with Comfort Access, the identification transmitter must be inserted in the ignition lock. Cables routed through open windows could be damaged when the windows are started automatically.
Make sure that the vehicle system voltage does not drop below 13.0 volts while programming is in progressġ2.Set up connection between workshop network, vehicle interface and vehicleġ3.Check cable routing. Low system voltage may cause programming to cancel. Please refer to the operating instructions for the battery chargerġ1.Do not connect or disconnect the battery charger during programming. The battery charger connected during programming must be run in “external power supply mode with battery connected”. Make sure that the wipers can move freelyĩ.Make a note of all stored radio and TV frequencies as well as the navigation destinationsġ0.Connect up a BMW ICOM BMW Group-approved battery charger in the engine compartment. The wipers may be actuated during programming and initialization. The basic requirement for efficient programming is that the vehicle is correctly prepared.Ģ.Wherever possible, protect vehicle from direct sunlightĤ.Shift manual transmission to Neutral or automatic transmission to Park.ĥ.Activate electromechanical parking brake or apply parking brakeĦ.Make sure that the temperature of the transmission fluid is between -40 ☌ (-40 ☏) and 85 ☌ (185 ☏)ħ.Switch off all electric loads, lights and turn signal lampsĨ.Switch off wiper/washer system.
Preparing vehicle programming and finishing off This instruction show you how to use BMW ISTA software to perform programming and coding work.
0 kommentar(er)
